How To Time A John Deere 346 Baler
If you want to know how to time a John Deere 346 baler, it’s best to refer to the operator’s manual. The timing process is governed by two factors. The first is the amount of hay placed on the left side of the bale case. The second is the rate at which the hay is pushed into the baler. Changing this setting is very important, because it will help you to get the most out of your machine.
To adjust the timing slot on a John Deere 346 baler, start the machine by turning the flywheel counterclockwise. To do so, ensure that the feeder fingers are between 10.5 and 11.5 inches from the edge of the bale case. The needle points should be even with the channels in the front of the baler. Then, turn the flywheel clockwise until the face of the plunger reaches the middle of the plunger head.
The next step is to set the attitude of the baler. This setting allows the feed to penetrate the hay more to the left than toward the right. For a light windrow, you should adjust the distance of the feeder fork from the left end slot to 9.5 to 11.5 inches. Make sure to adjust the sprocket and chain idler to keep the right distance.
Before attempting to time a John Deere 346 baler, make sure the feeder forks are set correctly. The left end slot should have a minimum distance of 11.5 inches from the front feed tube. You should also be sure that the sprocket and chain idler are properly adjusted. This will ensure the correct amount of penetration for the hay.
You should adjust the tucker finger adjustment to the left end slot. The width of the tucker finger should be about nine to 11 inches from the left end slot. You can also adjust the sprocket to make sure that the feed fork is set to the proper distance. The drive chain idler must be adjusted to ensure that the machine is in the correct time.
The John Deere 346 baler is a versatile piece of equipment that will get the job done. It has the ability to push a lot of hay, but there are also its shortcomings. Nevertheless, this is a great piece of machinery for a farmer to use. If you are considering purchasing one, you should consider the following tips. This way, you will get the best results from your investment.
The timing slot of a John Deere 346 baler is very important. It is important to keep in mind that the feeder fingers should be approximately 10.5 to 11 inches from the bale case. The needles should be even with the top of the channels of the bale case. The needle points should be pointed downward. Then, the operator should adjust the flywheel clockwise to achieve the desired hay weight.
The other factor that is essential for proper operation is the distance between the forks. The forks should be about 9 to 11 inches from the left end slot. The feeder fork should be positioned in the lower hole of the baler. Then, the flywheel should be turned counterclockwise to bring the plunger to the rearward stroke. The face of the plunger should be in the middle of the front feeder fork slot.
The first step to correctly time a John Deere 346 baler is to make sure the feeder forks are correctly aligned. The distance between the feeder forks and the left end slot should be between nine and eleven inches. To fine tune the spacing between the forks, the sprockets should be turned counterclockwise. A sprocket must be inserted in the lower hole of the fork.
The second step in timing a John Deere 346 baler is to make sure the feeder forks are in line with the bale groover. A faulty placement will result in a bale that isn’t tight enough. When the forks are in place, the plunger should be able to slam. If the forks aren’t in line with the blades, the forks will fall into the lower left corner of the bale.
