John Deere Gator 6×4 Dash Light Cover
If you own a John Deere gator 6×4, you may notice that the dash light is not working. This may be because of faulty wiring or a blown fuse. Another possibility is that the engine is overheating. This can be easily fixed by jump starting it from the battery. If you suspect this, check the electrical connections for faulty wiring and replace them as needed.
The 6×4’s dash light is controlled by a sensor temperature switch. It should close the circuit when the vehicle gets warm. The same applies to the radiator and the engine. I have found that the sensor temp switch controls the fan and light. To fix this problem, you will need to open the dash light and look for the two temp switches. The engine temp switch controls the fan and the radiator temperature switch controls the light.
In this case, you will need to do some work on the HPX fan motor to make it work. Using a continuity tester, you can test the fan motor and see if it works. You can try jumping the fan motor on the engine temperature switch and the radiator temp switch. You can check your wiring before you attempt to replace it. The other thing you should do is to check the thermostat. The heater control module is located in the radiator.
There are two different switches that control the dash light. The radiator temperature switch controls the fan while the engine temperature switch controls the light. If either switch is out of action, you should replace the heater. The radiator temp switch will turn on the light. The HPX fan may need some additional work, so you can jump it. If the heater does not work, you may need to check the heater.
The HPX fan requires some work. If you can’t jump it, the fan motor may be malfunctioning. If this is the case, you should check the temperature switch for the engine. Then, use a continuity tester to test the radiator and the dash light. The continuity tester should show a good signal both when hot and cold. You can now see if the dash light is working or not.
The HPX fan needs some work to work. To jump the fan motor, you need to find two terminals. The 6×4 has two temp switches. The engine temperature switch and the radiator temp switch turn on the fan. This should help you to check the fan and light, but it is still not working. After a few hours, it’s working again. If the HPX fan isn’t working, you need to try jumping the fan motor.
The HPX fan is responsible for turning on the light. To jump the fan, you need to find the two terminals. Then, you need to jump the HPX fan motor and the radiator temp switch. You should see a continuity tester that shows both voltages when the engine is hot or cold. After the heater is turned on, turn on the light and the fan. You can check this on the dash.
The HPX fan is responsible for turning on the light. You need to jump the fan motor. The radiator temp switch is the only one that can work on the 6×4’s engine. The two temp switches should be the same. You can then jump the fan. Then, you can check the engine. The dash light will be on. The heater is the main component of this truck, so it will require to work on a regular basis.
The heater fan on a John Deere gator 6×4 is controlled by a sensor temperature switch. During the winter, it will not operate. This can cause the light to go out when the radiator is hot. In this case, you should look for the engine’s temp switch. This will turn the fan on. After that, check the coolant thermostat and the temperature switches.
