John Deere Van Brunt Grain Drill Parts Diagram
To find a John Deere Van Brunt grain drill parts diagram, you must know the model number of the equipment. There are several parts available online. However, not all of these parts are the same for every model. If you are not sure what part you need, you can get the information from the operator manual. If you have a spare part, it is best to go to the nearest dealer.
The first thing you need to do is to attach the feed cups. Then, you should secure the front box straps to the center board of the drill. If you have a gang press or hoe drill, you should have a covering chain attached to the bottom of the second boot. If you have a drill with one lifting lever, you should install the J100 rear box brace. If you have two lifting levers, you should install J100 rear box braces.
To install a lifting lever, you should bolt the ratchet to the axle bearing on the front end of the drilling machine. Also, attach the pole clips and the swivels. You should then attach the tilting lever ratchet. On the left side, you should attach the long shifter bar. The rear box brace should be fastened with bolts through the rear strap of the machine.
The back box should have two lifting levers. The back box should be secured to the center box board with the square ends of the bolts. A lifting lever ratchet should be fastened to the axle bearing. A guiding chain is used for gang press drills and hoe drills. It is important to note that the end-hanger brackets and end-hanger brace should be secured with the bolts on the right side.
The front end of a gang press must be secured with bolts on the back end of the cab. The rear end of a hoe drill should have a guiding chain and two lifting levers. On a gang press drill, the guiding chain should be attached to the left end of the axle bearing. The rear side of a gang press drill should have a long shifter bar.
A guiding chain is not used on hoe drills. On a gang press drill, it is attached to the rear end of the tractor. On a 17-inch-size van brunt grain drill, it should be fitted with J100 rear box braces. To avoid rusting, attach the guiding chain to the axle bearing. On a gang press drill, a lifting lever must be attached to the left end of the axle bearing.
